Thanks! Here is my item list atm.
Item List
------------
Helmet - Jimmi - In hand
Armor - Jimmi - In hand
Paint - on hand
Gloves - Enderd Finders - in hand
soft goods -jimmi
Boots - Imperial - in hand
Ammo Pouch - Epic Militaria -In Hand
Helmet Decal - Van Oaks Prop Foundry on Etsy - In hand
Balaclava - on hand
Belt - in hand
Audio w/ replacement snout - Ukswrath - In hand
Helmet fan kit - Ukswrath - In hand
E-22 - BreakingTheMold3D - ordered
shotgun shells - shapeways - in hand
------------
Here was my last picture post from my pathfinders build thread. My goal is to wear this to Celebration and I'll be in Orlando the week before so <3 weeks left.
My jimmi helmet all primered up and eyes cut out. Cutting the eyehole was a bit harder since it is fiberglass.
Fresh shoes from Imperial Boots
Everything has been inside sanded and painted with 2 coats black primer and a coat of Sahara Beige. This Montana paint is the best spray paint I've ever worked with. So nice! Not pictured I started painting the other colored pieces. Stupidly painted a mismatched pair so I'll have to paint a red piece sahara beige again! Hmph!
Gloves done. Obviously the armor pieces are more centered when the gloves are on my hands!
Lower arms before painting red/blue/yellow. I glued one edge and used velcro on the other. These were the first pieces I assembled and I used a long strip of velcro when I should have used a couple of smaller pieces. It is industry strength so it holds real well but I may have to change it up in the future.
So I posted before I have mega calves. I checked these when I first got them and it seemed I would have some clearance. As seen here I am even using para cord on the front to give me a bit more width. I tried them tonight with jeans on and I could not get them to fit. I may have to either let out a bit more on the front (although at some point it will be noticeable) or maybe do something with the pants.
I have my shirt and pants BUT they are not a great fit. I'll lay the blame on me because I think I did not do the best job giving measurements (I tried and even had a 2nd person help!). ESPECIALLY in the lower leg area. I plan to get it fixed but now with my lower leg fitment issue I'm wondering if maybe I get a thinner material installed where it is covered by the lower legs. That would help me out a bunch!
I'm trying to finish up for celebration so I have a few weeks left. I'll try to update more often over the coming weeks.
